Epoxy Protect™ is a new generation catalyst-cured polyamine epoxy floor coating system that utilizes specially formulated components producing excellent adhesion, build, hardness and durability not commonly available from water based coatings. Epoxy Protect™ is easy to use and cures fast. It is cured enough for motorized traffic in just 48 hours. The zero VOC formula is low odor and eco-friendly. Adhesion, hardness, chemical resistance, color and gloss retention are all excellent. Epoxy Protect™ is self priming and surface tolerant. It holds up to heavy motorized traffic, high impacts and abrasions. It is acceptable for foodservice areas, commercial, industrial, manufacturing and consumer applications. It may be used indoors or in outdoor applications. Epoxy Protect™ may be used with or without aggregates, Super-Fleck Chips and other decorative elements. Fo best results apply two coats within 24 hours of each other.
National Paint WB Epoxy Tie-Kote is a two component water based epoxy tie-coat/sealer with excellent adhesive properties existing one and two part finishes. Primarily used on cleaned existing finishes which will be over coated with a two component solvent based finish which may attack the existing finish and cause a loss of adhesion. Can be used over chlorinated polymer pool paints, conventional solvent based and water based finishes such as alkyds, vinyls, acrylics and latex. Ideally applied by roller or brush but can be sprayed if desired.
Universal Tie-Coat/Sealer for Many Pool and Industrial Maintenance Applications
Allows for Easy Conversion From Conventional Finishes to Two Part Solvent Based Epoxy Finishes
Excellent Water and Chemical Resistance
Heavy Duty 4:1 Epoxy Primer
Ease of Clean Up with Water
Suggested Uses: Water Based Tie-Kote or Sealer
Colors: Clear Amber
Vehicle Type: Amine Adduct Resin in Water
Solids By Volume: 47.0 +/- 1.0%
VOC Content: 0 grams/liter (reacted)
Weight per Gallon: 8.6 +/- 0.2 pounds
Recommended Dry Film Thickness: 2.0-2.5 mils
Coverage: Approximately 303 square feet per gallon at 2.5 mils DFT
Pot Life: 2-3 Hours
Shelf Life: 24 Months
Average Dry Time: Dries to touch in about 1 hour at 70-75 deg F. Can be top coated with solvent based epoxy finishes after an overnight cure.
Recommended Reducer: None recommended. Use tap water if necessary
Clean Up: Use tap water
Surface Preparation: Surface must always be clean, dry and properly prepared prior to painting. Failure to do so will lead to eventually blistering and/or peeling. High pressure fresh water clean if possible or solvent clean to remove all surface contaminants. Allow to thoroughly dry prior to over coating.
General Application: For use as a tie-coat/sealer over existing finishes that are desired to now be painted with solvent based epoxies. Apply by roller or brush. Add up to 10-15% by volume of tap water but only if necessary. Apply one or two coats if needed to meet dry film thickness requirements. Allow 15-20 minutes induction time after the curing agent component is added.
Mixing and Thinning: Shake or mix each component thoroughly. Add the curing agent component to the base component and stir thoroughly. Continue to stir while using.
Existing Painted Surfaces: First ensure the existing surface is compatible with a two component water based