LIMITATIONS: Do not apply if material, substrate or ambient temperature is below 40°F or above 95°F.
VEHICLE TYPE: Phenolic Resin
SOLVENT TYPE: High Flash Naphtha, Xylene
VOC: 2.9 lbs. / gal (350 grams / liter)
SOLIDS BY WEIGHT: 53%
WEIGHT PER GALLON: 10.2 lbs. per gallon (varies by color)
RECOMMENDED DRY FILM: 4.0 mils
COVERAGE: Theoretical coverage at two mils dry is 400 square feet per gallon, and recommended thickness of 4 mils dry would require 2 full coats. Material losses during mixing and application will vary and must be taken into consideration. Expect 50% less coverage on bare, rough or sandblasted surfaces.
VISCOSITY AT 75°F (24°C): 70-80 KU
AVERAGE DRY TIME - 77°F: Dries to touch in 4 hours. Lower temperatures & higher humidity will slow down dry times.
RECOAT TIMES - 77°F: Recoat in 4-6 hours. Longer times are needed for lower temperatures.
RECOMMENDED REDUCER: Use as packaged. Thinning product may make this product non compliant in your local area.
RESISTANCE TO: Chemical Resistance, Abrasion, Oils, Grease, Rust, Corrosion, Mildew, Chipping and Fading
RECOMMENDED PRIMER: Rust No More™ Primer
APPLICATION: Brush, Spray or Roller Roll: 3/8” - 1/2” nap mohair metal, lambskin, phenolic core roller. Keep roller wet. Roll in one direction, rewet, then cross roll. Product to be used as packaged. Reducing may make this product non-compliant in your local area. Spray: Conventional Air Gravity Feed 59-70 psi, Tip Size .055-.070, Airless 2200-2500 psi, Tip Size .013-.017.
SURFACE PREPARATION: For optimum performance, scrape off loose rust and paint with a wire brush, and also remove all dirt, oils and grease. Solvent wipe down to remove all residue. Apply topcoat.
POT LIFE: Not Applicable
SHELF LIFE: Minimum 24 months
MIXING: Mix for 10 minutes, making sure that all solid material is mixed thoroughly.