-
- RUST NO MORE™ needs no special surface treatment.
- RUST NO MORE™ needs no sanding or deglossing.
- RUST NO MORE™ penetrates the porous rust reaching the metal underneath.
- RUST NO MORE™ will not lift, blister, or peel away from its leading edge.
- RUST NO MORE™ tested scientifically against leading rust/corrosion control products.
-
- LIMITATIONS: Do not apply if material, substrate or ambient temperature is below 40°F or above 95°F.
- COLORS: Gray
- FINISH: Flat
- VEHICLE TYPE: Phenolic Resin
- SOLVENT TYPE: High Flash Naphtha, Xylene
- VOC: 2.9 lbs. / gal (350 grams / liter)
- SOLIDS BY WEIGHT: 53%
- WEIGHT PER GALLON: 10.2 lbs. per gallon (varies by color)
- RECOMMENDED DRY FILM: 4.0 mils
- COVERAGE: Theoretical coverage at two mils dry is 400 square feet per gallon, and recommended thickness of 4 mils dry would require 2 full coats. Material losses during mixing and application will vary and must be taken into consideration. Expect 50% less coverage on bare, rough or sandblasted surfaces.
- VISCOSITY AT 75°F (24°C): 70-80 KU
- AVERAGE DRY TIME - 77°F: Dries to touch in 4 hours. Lower temperatures & higher humidity will slow down dry times.
- RECOAT TIMES - 77°F: Recoat in 4-6 hours. Longer times are needed for lower temperatures.
- RECOMMENDED REDUCER: Use as packaged. Thinning product may make this product non compliant in your local area.
- RESISTANCE TO: Chemical Resistance, Abrasion, Oils, Grease, Rust, Corrosion, Mildew, Chipping and Fading
- RECOMMENDED PRIMER: Rust No More™ Primer
- APPLICATION: Brush, Spray or Roller
Roll: 3/8” - 1/2” nap mohair metal, lambskin, phenolic core roller. Keep roller wet. Roll in one direction, rewet, then cross roll. Product to be used as packaged. Reducing may make this product non-compliant in your local area.
Spray: Conventional Air Gravity Feed 59-70 psi, Tip Size .055-.070, Airless 2200-2500 psi, Tip Size .013-.017. - SURFACE PREPARATION: For optimum performance, scrape off loose rust and paint with a wire brush, and also remove all dirt, oils and grease. Solvent wipe down to remove all residue. Apply topcoat.
- POT LIFE: Not Applicable
- SHELF LIFE: Minimum 24 months
- MIXING: Mix for 10 minutes, making sure that all solid material is mixed thoroughly.
- PACKAGE: 1 Gallon cans
- CLEANUP: Xylene or Lacquer Thinner for Equipment.
-